ATTO iPBridge™ 1500E
Gigabit Ethernet and SCSI
GbE Interface:
•10/100/1000 GbE RJ45 Ethernet port
•Supports IP v.4
•Supports iSCSI Protocol 1.0
•Compliance with IEEE 802.3ab GbE
•Compliance with IEEE 802.3x Flow Control
•SNMP MIB 2 support
•Supports Jumbo Ethernet frame
SCSI Interface:
•Single
•Ultra160 LVD SCSI – 160 MB/sec. maximum throughput
•Backward compatible with all
•Supports
Environmental and Physical Characteristics
Configurations:
• Embedded Board
Dimensions:
•Embedded Board: 4.4” W X 6.4” L
Operating Environment:
• Operating Temperature:
Power: Standard 4pin power connector, 12V, 1.5A Nominal power consumption: 1A @ 12V
Weight: 1.5 lbs
Management
Operating Environment:
•Operating system independent
•Supports all SCSI devices including hard disk drives, tape drives, RAID controllers, DVD, MO and CD libraries
•Multiple interface orientations available - Ethernet and RS232 ports can be located on either the long edge or short edge of the board (see Figure 2 and 3)
Local and Network Management:
•ExpressNAV™ integrated management console for remote configuration, management and diagnostic capabilities
•Command line management access via Ethernet and RS232
•Local diagnostics supported through SNMP, Telnet, and FTP
•Includes support for DHCP, ICMP, and RMON
•Built in memory has ECC detection and correction
•User accessible reset switch
•Built in watchdog timer
•Automatically detects and maps all connected devices at power on
Figure 2 – iPBridge 1500E Standard Embedded Configuration
Figure 1 – iPBridge 1500E Board Detail
Figure 3 – iPBridge 1500E Optional Desktop Configuration
Rev 1, 9/04
