83

ATTO Technology Inc. Diamond Storage Array Installation and Operation Manual
8.2 Resetting Defaults

Resetting the Diamond Storage Array to defaults does not alter the RAID configuration , zoning

configuration, IP configuration or Telnet information. However, resetting the array to factory defaults

is a last-ditch effort to recover from corrupt configurations or complete failure. All data is lost, but the

zoning configuration remains.

Default

If you need to return to the default settings of the

Diamond Storage Array but do not want to lose

data or Ethernet settings, use the CLI command

RestoreConfiguration default

in CLI mode or in the

Advanced CLI

configuration page of the

ExpressNAV interface.

Note
Resetting the array to factory defaults is a last-
ditch effort to recover from corrupt
configurations Using
RestoreConfiguration
default
or
RestoreConfiguration factory
default
does not affect the zoning
configuration.
To restore the array to factory default, type
ZoneClearAll
ZoneCommit
Because the ExpressNAV pages take you
through this process easily, the following
instructions are based on the CLI commands.
Use these instructions as a guide in
ExpressNAV.

Return to Default settings

1 Connect to Diamond Storage Array services via
the RS-232 port or the optional Ethernet
management services card (refer to
Accessing
the Array
on page 17). You should now be in
Command Line Interface.
2 Continue with the CLI or access the
ExpressNAV interface (refer to
ATTO
ExpressNAV: Browser-based Interface
on page 25).
3Type
RestoreConfiguration default to reset
the system configuration (See Exhibit 8.2-1 for
a list of configurations which change).
4Type
FirmwareRestart or cycle power of the
array.
5 Reboot the host PC after the array completes
its power on cycle.

Factory Default

Note
Resetting the array to factory defaults is a last-
ditch effort to recover from corrupt
configurations Using
RestoreConfiguration
default
or
RestoreConfiguration factory
default
does not affect the zoning
configuration.
To restore the array to factory default, type
ZoneClearAll
ZoneCommit
CAUTIONCAUTION
Data will be lost if you follow these
procedures. Make sure you have no other
choice before resetting the array to factory
defaults.

To reset to Factory Defaults, firmware version

2.5.3 or higher

1 Connect to Diamond Storage Array services via
the RS-232 port or the optional Ethernet
management services card (refer to
Accessing
the Array
on page 17). You should now be in
CLI.
2 Continue with the CLI or access the
ExpressNAV interface (refer to
ATTO
ExpressNAV: Browser-based Interface
on page 25).
3Type
RestoreConfiguration factorydefault to
reset the system configuration. (See
Exhibit 8.2-1 for a list of configurations which
change).
4Type
FirmwareRestart or cycle power of the
array.
5 Reboot the host PC after the array completes
its power on cycle.