Attwood 6375D installation instructions Zamak 1-Mile Combination Sidelight

®

3

Figure 1

Zamak 1-Mile Combination Sidelight

6375D

Installation Instructions

Attwood marine hardware, navigational lighting, bilge pumps, and other marine accessories are specified more than any other brand by America’s best-known boat manufacturers as original equipment. Look to Attwood for quality replacement parts and marine accessories.

SAVE THESE INSTRUCTIONS
Form Number 69305 Rev. B	03-10

REQUIRED FOR INSTALLATION

• Drill with ₈¹⁄" (3mm) and ₄¹⁄" (6mm) dia. bits.
• Screwdriver and two #8 x ₄³⁄" (19mm) stainless screws.
•	Suitable marine sealant.
•	2-conductor, 14-gauge wire for connection to switch and
	power supply.

Bulb •

•

Mounting •

Screws

(Not Supplied)

•Cover

Lens

•	Cover Retention
	Screws

• Fuse holder with 1.0-amp (maximum) fuse.

• ON/OFF switch (Attwood Numbers: 7563, 7589).

LOCATION

1.Position light on horizontal (± 5°) deck surface at forward tip of the bow on boat centerline.

2.Ensure that there are no front or side obstructions within arc of visibility (112.5° each side).

MOUNTING INSTRUCTIONS

1.Align center of light with boat centerline. Use base to mark mounting screw pilot holes. (See Figure 1.)

2.Drill two ₈¹⁄" (3mm) pilot holes. Beneath base, drill a ₄¹⁄" (6mm) diameter hole for power wires.

3.Attach power wires to suitable switch, 1-amp fuse, and power source.

4.Apply marine sealant around base and wire hole. Use #8 screws to fasten light to deck.

MAINTENANCE

Replace bulb with #90, 7.5 watt type (Attwood #9232):

1.Remove light from deck. Remove cover retension screws, base and lens. Replace bulb. (See Figure 1.)

2.Reassemble and install light.

© 2003 Attwood Corporation

1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com