Attwood 91022 Final Wiring for, Higher Voltage can Cause Damage to Light and Wire Circuitry

FINAL WIRING FOR:

91020, 91022 (2 wire base): Connect one black wire to the battery ground (-) harness, using a crimp-on wire connector. Attach the remaining black wire to the positive switched wire from the navigation light switch.

91021 (3 wire base): Connect black wire to the battery ground (-) harness, using a wire connector. Connect the blue wire to the wire from the switch for the courtesy light. Use a wire connector to make the connection. Connect the gray wire to the wire from the switch for the navigation running lights using a wire connector.

All positive wires must be fused according to light specs to protect the circuit. MAKE SURE POWER SOURCE IS 12-VOLT D.C. ONLY.

HIGHER VOLTAGE CAN CAUSE DAMAGE TO LIGHT AND WIRE CIRCUITRY.

Insert light pole into base and press down to make contact. Insert lock collar into base opening, rotate if necessary to push it down into base. Rotate collar until tight to hold light pole in base. Test light operation. Remove and stow light. Close cover to protect contacts when not in use.

Part #91020, 91021 Part #91022

This product carries the standard Attwood one-year limited warranty. See product catalog for details.

© 2003 Attwood Corporation

1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com