TH104PLUS 400-104-004-D 2008-01-29 2/4
2) Mount the thermostat
Push the excess wires back
inside the electrical box.
Secure the thermostat to the
electrical box using the provided
screws.
Insert the screws through either
the right or left pair of mounting
holes on the thermostat.
3) Complete the installation
NOTE: If there is a protective film or sticker on the thermostat’s
screen, peel it off.
Apply power to the heating system. Verify the installation by checking
that the heater can be turned On and Off by raising and lowering the
setpoint using the Up and Down buttons.
WARNING: Keep the thermostat's air vents clean and free from
obstructions.
The thermostat normally displays the room (measured) temperature.
• To view the set temperature (setpoint), press the Up or Down
button once.
• To change the setpoint, press the Up or Down button until the
desired setpoint is displayed.
• The screen is backlit for 10 seconds when any button is pressed.
The factory settings are inside the shaded cells of the following table.
WARNING: The clock loses its setting whenever you change the
thermostat’s configuration.
Temp era tur e di sp lay
To change the temperature display between °C and °F:
nOpen the thermostat’s door.
oPress and hold the Day button.
pInsert a pointed object (e.g., paperclip) in the reset opening.
Remove it when the thermostat’s screen becomes blank.
qWait one second and release the Day button.
Time display
To switch between the 12-hour format and the 24-hour format:
nOpen the thermostat’s door.
oPress and hold the Hour button.
pInsert a pointed object (e.g., paperclip) in the reset opening.
Remove it when the thermostat’s screen becomes blank.
qWait one second and release the Hour button.
Control type
Use proportional control (default setting) in most cases as it pro-
vides better temperature control.
Use conventional control if you have a fan-forced heater.
Fan is displayed when conventional control is selected. To switch
between the two types of control:
nOpen the thermostat’s door.
oPress and hold the Min button.
pInsert a pointed object (e.g., paperclip) in the reset opening.
Remove it when the thermostat’s screen becomes blank.
qWait one second and release the Min button.
The clock must be set when Time flashes on the
screen.
nOpen the thermostat’s door.
oPress the Day button to set the day.
pUse the Hour and Min buttons to set the clock.
qPress the button to exit.
The thermostat has three modes of operation:
Automatic mode
To use the Automatic mode, press the Mode button
until Auto is selected (outlined) on the screen. The cur-
rent period number will appear.
In this mode, the thermostat automatically adjust its
temperature setpoint according to the period of the day
(wake up, leave for work, return home and sleep).
You can program up to 4 periods in a day. You can set 2 different
programs: one for the weekdays (Monday to Friday) and another one
for the weekend (Saturday and Sunday).
pTemperature Display and Setting
3.
qConfiguration
4.
Temperature display °C °F
Time display 24h 12h
Temperature control Proportional
(15-second cycles) Conventional
(± 0.5°C deadband)
rClock and Day Setting
5.
sModes of Operation
6.
400-104-004-D (TH104PLUS) ENG.fm Page 2 Tuesday, January 29, 2008 4:21 PM