pTemperature Display and Setting
The thermostat normally displays the actual (ambi- ent) temperature.
• To view the setpoint temperature, press once on either temperature adjustment button. The icon
appears during the setpoint display.
•To change the setpoint temperature, press the appropriate but- ton until the desired value is displayed.
qPower Outage
During a power outage, the setpoint is saved in memory. You do not need to adjust the temperature when power returns.
rSpecifications
-Supply: 120/240 VAC, 50/60 Hz
-Minimum load: 2 A (resistive only) 500 W @ 240 VAC 250 W @ 120 VAC
-Maximum load: 12.5 A (resistive only) 3000 W @ 240 VAC 1500 W @ 120 VAC
-Display range: 0 °C to 50 °C (32 °F to 122 °F)
-Setpoint range: 5 °C to 30 °C (40 °F to 85 °F)
-Storage:
-Approval: c UL us
sTroubleshooting
PROBLEM | SOLUTIONS | |
|
| |
| This is normal. Under normal operation, the | |
Thermostat is hot. | thermostat housing can reach a temperature | |
| between 35 °C (95 °F) and 40 °C (104 °F). | |
|
| |
| Correct if any the following conditions | |
| applies: | |
Displayed tempera- | • The thermostat is exposed to air draft. | |
ture is wrong. | • The sticker on the thermostat’s screen | |
has not been removed. | ||
| ||
| • The thermostat is located near or above | |
| a heat source such as a light dimmer. | |
|
| |
| The thermal protection device on the heater | |
Display disappears | has temporarily opened. This can happen if | |
and reappears after | the heater is obstructed by furniture or curtain | |
a few minutes. | and has overheated, or if the heater’s thermal | |
| protection device is too sensitive. | |
|
| |
Display looks faded | The heating system is less than the required | |
when heating is | minimum load. This thermostat cannot be | |
activated. | used below that rating. | |
|
|
;Warranty
Aube warrants this product, excluding battery, to be free from defects in the workmanship or materials, under normal use and service, for a period of three (3) year from the date of purchase by the consumer. If at any time during the warranty period the product is determined to be defective or malfunctions, Aube shall repair or replace it (at Aube's option).
If the product is defective,
(i)return it, with a bill of sale or other dated proof of purchase, to the place from which you purchased it, or
(ii)contact Aube. Aube will make the determination whether the product should be returned, or whether a replacement product
can be sent to you.
This warranty does not cover removal or reinstallation costs. This warranty shall not apply if it is shown by Aube that the defect or mal- function was caused by damage which occurred while the product was in the possession of a consumer.
Aube's sole responsibility shall be to repair or replace the product within the terms stated above. AUBE SHALL NOT BE LIABLE FOR ANY LOSS OR DAMAGE OF ANY KIND, INCLUDING ANY INCI- DENTAL OR CONSEQUENTIAL DAMAGES RESULTING, DIRECTLY OR INDIRECTLY, FROM ANY BREACH OF ANY WAR- RANTY, EXPRESS OR IMPLIED, OR ANY OTHER FAILURE OF THIS PRODUCT. Some provinces, states or regions do not allow the exclusion or limitation of incidental or consequential damages, so this limitation may not apply to you.
THIS WARRANTY IS THE ONLY EXPRESS WARRANTY AUBE MAKES ON THIS PRODUCT. THE DURATION OF ANY IMPLIED WARRANTIES, INCLUDING THE WARRANTIES OF MERCHANT- ABILITY AND FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED TO THE
This warranty gives you specific legal rights, and you may have other rights which vary from one province, state or region to another.
Customer assistance
If you have any questions about the product installation or operation, or concerning the warranty, contact us at:
705 Montrichard
Canada
Tel.: (450)
Fax: (450)
Email: aube.service@honeywell.com
For more information on our products, go to
www.aubetech.com
TH108 | 5/16/06 | 2/2 |
