Main Configuration Window – Channel Setting Tab (Continued)
The software can configure the following channel functions:
Copy Channel Information (CH1 CP) button
Clicking this button copies channel one’s settings to the other seven channels.
INPUT ATT
Allows selection between 0 dB (MIC) and
(Note: if LINE is selected, Phantom will be grayed out and if PHANTOM is on, LINE will be grayed out.)
PHANTOM
Turns 48V phantom power on or off.
PRIORITY
Sets the channel’s priority status.
LOW FREQ CUT
Turns on the channel’s
FORCE ON
Allows channel to turn on, when external contact closure is activated, overriding any priority settings.
Note: Force on/off settings from external contact closure will override force on/off settings from PC.
FORCE OFF
Allows channel to turn off when external contact closure is activated, overriding any priority settings.
GATE ATT
When a channel is closed, its output is not entirely cut off, but attenuated. GATE ATT sets the amount of attenuation when the channel gate is closed (channel is off).
DIRECT OUTPUT
Allows the signal on each channel to appear on the Direct Out terminal before or after the channel’s gate.
INITIALIZE
Clicking these buttons sets a channel or all channels to factory default settings.
Note: when any of the INITIALIZE or CH1 CP buttons are clicked, a confirmation box appears, clicking OK begins the process. During the process, a blue progress bar appears in the rectangle in the windows lower left corner.
8