Receiver Operation

Each unit provides two selectable receiving frequencies.

1)Switch the Channel Selector Switch to the same channel as the one selected on the transmitter (A or B).

2)Attach the receiver to the video camcorder by inserting the mounting bracket foot into the camcorder’s accessory shoe.

3)Connect the mini-plug audio signal cable from the Mic Out jack on the receiver to the external mic jack on the camcorder.

4)Attach the monitor earphone to the Phone Out jack on the receiver to listen to the signal.

5)Turn the Power ON/OFF switch to the ON position (the LED indicator will light).

Helpful Hints

If the selected channel is noisy, switch both the transmitter and receiver to the other channel.

If there is a “dead spot” in a room (indicated by noise on the external earphone), try a slight change of position or try changing frequencies.

Low ceiling fluorescent lighting, overhead telephone lines or close proximity to metal fences can all cause static. If this occurs, try a slight change of position and/or try changing frequencies.

When the battery voltage drops below 6V, the LED indicator will go out. This means you need a new battery.

Turn off the power whenever the units are not in use. Remove the batteries if the units will be out of service for a long time.

NOTE: There are no user-adjustable parts inside the transmitter or receiver. Do not attempt to open or make any adjustments.

5

Page 5
Image 5
Audio-Technica PRO88W owner manual Receiver Operation, Helpful Hints