Audio Authority Model 1171 User Manual 11
Limited Warranty
Should any consumer use product manufactured by Audio Authority fail due to defects in materials or
workmanship within one year from the date of the original sale to the end-user, Audio Authority guarantees
to replace the defective product at no cost. Freight charges for the replacement unit will be paid by Audio
Authority (Ground service only). A copy of the invoice from an Authorized Reseller showing the item
number and date of purchase (proof-of-purchase) must be submitted with the defective unit to constitute a
valid in-warranty claim.
Units that fail after the warranty period has expired may be returned to the factory for repair at a nominal
charge, if not damaged beyond the point of repair. All freight charges for out-of-warranty returns for repair
are the responsibility of the customer. Units returned for repair must have a Return Authorization number
which can be obtained by calling 800-322-8346.
This is a limited warranty and is not applicable for products which, in our opinion, have been damaged,
altered, abused, misused, or improperly installed. Audio Authority makes no other warranties either
expressed or implied, including limitation warranties as to merchantability or tness for a particular purpose.
Additionally, there are no allowances or credits available for service work or installation performed in the
eld by the end user.
Tip = Signal
Sleeve = Ground
WARNING: Use only
passive emitters,
without a powered
connecting block.
Tip = Signal
Ring = Ground
Sleeve = +12 Volts
WARNING: Connect
receivers (12V only) to
Wallplate with no
connecting block or
other power source.
Emitter Pinout
A passive emitter usually
has a two-conductor plug.
Receiver Pinout
Receivers are powered
by 12 volts on the sleeve
contact of the 9878
Wallplate IR jack.
Using Compatible IR Products
Infrared signals may be transmitted from
any Wallplate location back to the 1171
IR output by connecting a compatible IR
receiver to the Wallplate’s IR jack. The
Wallplate provides 12V power to the IR
receiver;
do not use IR receivers that
provide their own power or damage
could result.
Connect a compatible emitter to the
1171’s IR output. Use only passive emit-
ters or damage could result.
!