![Connecting to an IR network](/images/new-backgrounds/26625/266257x1.webp)
they must be placed far away, compensate for losses of the long coaxial cable by increasing the cable compensation setting by one click for each 200 feet of coaxial cable length (see diagram below). For example, if the coaxial cable length from source to 9871 Driver is 220 feet (1 click) and the Cat 5 cable length to a certain wallplate is 250 feet (2 clicks), the correct Cable Length Compensation for that wallplate is 1 + 2 = 3 clicks. Conditions vary, so it is best to verify settings using the video display that will be installed in each location.
RCA Cable Length = 220 ft. | 9871 |
| |
| Driver |
Cable Length
Compensation = 4
Cable Length
Compensation = 3
AV Source Component
A B
Cat 5 Cable Length = 370 ft. | Cat 5 Cable Length = 250 ft. |
Connecting to an IR network
The DuoDrive does not have an IR remote control system; it provides a discrete
AV Source
IR Remote
Control
System
|
| Note: IR remote control | |
|
| system and receivers are | |
9871 | Note: This | not included. | |
| |||
Driver |
| ||
configuration of two | IR Receiver | ||
| |||
| 9871 Drivers could | ||
|
| ||
| support four |
| |
| wallplates. |
|
AV Source
IR Receiver Tips:
A B
A B |
|
9879 | IR |
Wallplate | Remote |
Cat 5, Cat 5e, |
|
or Cat 6 Cable |
|
•Avoid IR interference from Plasma and LCD TVs, direct sunlight, fluorescent light, etc.
•Use
Connect only |
front OR rear |
IR jack |
2048 Mercer Road, Lexington, Kentucky
In Case of Difficulty
If any problems arise that are not covered in this manual, call Audio Authority Technical Support at