AudioBahn ABD40J owner manual Controls and Functions

CONTROLS AND FUNCTIONS

5

PWR	SUB
	LEVEL
MIN	MAX

							7
					ABD4 0 J			8
		WIDE
							POWER
					MAX	BASS	CONTROL
5	MIN		MAX
	SWEEP
							R
					-35Hz
					-50Hz
					-80Hz
6	MIN		MAX
	DIGITAL BASS RECONSTRUCTION PROCESSOR
	BALANCED
		INPUT			OUTPUT		+12V GROUND
	L	R	DASH REMOTE	L	R		REMOTE

1 3 2 4

1.Balanced Input: Low Input is used to balance the input circuit to help minimize noise. They are designed to handle high voltage signals up to 15 volts.

2.Outputs: RCA connectors must be connected to the next component after the bass processor, like a crossover, equalizer or amplifier. Remember the bass processor must be connected before a crossover.

3.Remote Control.

4.Power connector

5.Controls: These two knobs control the functions of the Bass processor features. SWEEP knob allows to choose the desired center frequency.

WIDE knob adjusts the frequency range of low impact processor.

6.The PFM subsonic filter switch: Bass Processor uses a PFM subsonic filter switch that will helps the speaker control and manage the power amplifier. This switch comes with three selections 35Hz/50Hz/80Hz frequency. In most programming systems is 35Hz, if you want to further protect your speaker system, try a higher frequency. Often, higher frequency sounds louder and clearer.

7.Maximize Bass Indicator: All three LED indicators flash when the maximization of the lower circuit is activated.

8.The L.E.D. indicates when the unit is on.