CAT700 Termination Manual

The directionality of the cable follows the direction of the printing

from source to destination and is indicated by arrows.

Step 1

Step 3

Place boot onto cable. Strip jacket back 0.75”. The directionality of the cable flows from Side #1 to Side #2 along with the arrows and direction of the printing. Side #1 is to the left of the razor blade, and side #2 is to the right of the boot.

Align wires into the formation below. There are no stripes on the white wires so carefully keep each one in its correct position. The separator will be put on later; the illustration below just shows the orientation of the wires.

Cut off the drain wires on Side #1 and twist the drain wires together on Side #2.

Step 2

Cut out the foil around the twisted pairs of wires.

If you have any questions or concerns – please call AudioQuest at (949) 585-0111 or email: info@audioquest.com

2

Page 2
Image 2
AudioQuest manual CAT700 Termination Manual