Audiovox 128-4874A installation instructions INSTALLATION - 1982 AND NEWER, Install the New Radio

CHEVROLET-OLDSMOBILE-BUICK-PONTIAC-GMC-CADILLAC-SATURN

INSTALLATION - 1982 AND NEWER

Important-This installation is designed for most 1982 and newer GM cars, trucks, and vans where an installation kit is required. See Kit Listing on Page 1 of this manual or refer to the in-store application chart. If a kit is not required, use the instructions on Page 3.

1.Remove the Existing Radio:

A.Remove the existing dashboard trimpanel surrounding the radio opening. This panel is usually secured by screws and/or snap-in clips.

B.Remove the screws used to secure the radio to the sub-dashboard.

C.Pull the radio forward to access the wiring and antenna cables plugged into the rear of the chassis.

D.Un-plug the wiring harness(es) and antenna cable and remove the radio.

2.Install the New Radio:

A.Follow the instructions included with the installation kit to attach the radio to the mounting plate supplied with the kit.

B.Place the radio near the dashboard so the wires can be led through the opening and following the instructions of Step 2 on Page 2 and diagram on Page 8, carefully wire the radio making certain all connections are secure and insulated and confirm proper operation.

C.Install the radio/mounting plate assembly to the sub-dashboard according to instructions of installation kit.

D.Attach one end of the perforated support strap (supplied) to the screw stud on the radio using the hex nut provided. Fasten the other end of the perforated strap to a secure part of the dashboard either above or

below the radio using the screw and nut provided. Bend the strap to position it as necessary. CAUTION: The rear of the radio must be supported with the strap to prevent damage to the dashboard from

the weight of the radio or improper operation of the radio due to vibration.

E.Replace the dashboard trimpanel.

F.Install knobs on radio shafts.

HEXNUT

PERFORATED STRAP

SCREWSTUD

SCREW

HEXNUT

RADIO

MOUNTING PLATE FROM KIT
	SHAFTNUT
(NOT INCLUDED WITH RADIO)

IMPORTANT

AMOUNTING KIT IS REQUIRED

FOR THIS INSTALLATION

EXISTING DASH TRIMPANEL

-4-