Audiovox 50-0244x-018 SERIES, 50-0244x-001 SERIES III. Installation of Console

III. INSTALLATION OF CONSOLE

NOTE: Additional assistance in mounting the overhead console in vehicle is

advised to prevent damage to console or components.

12.Install and route all video and audio cables, and any other added component requirements to their respective places in the vehicle. Refer to component installation instructions for wiring diagrams. The suggested routing of the video system cable is as follows: Above the headliner from video system to B-pillar. Rearward to the C-pillar. Down the C-pillar to the floor. Route the power lead to an accessory controlled source. Connect the ground lead to the vehicle chassis. Route the remaining wiring (RCA plugs, Remote Sensor extension, etc.) to the VCP location. See Figure 11. Connect per instructions included with the video system. If video system if to be used as a television, install an appropriate antenna per instructions included with the antenna.

FIGURE 11

Caution: Do not overtighten screws. Use extra support for the console until secured to the vehicle. Failure to do so may cause damage to console or installed components.

13.Raise console into approximate position and connect wiring to O.E. components.

14.Carefully position console against headliner. Loosely install using (2) two 6-32 X 3/4" screws (item 3 pg 2) through the smaller holes in bracket on console into threaded clips on mounting bracket.

15.Secure the front of console to the inner roof of vehicle using original screw in original location. See Figure 12.

16.Using an awl or similar tool, align the rear mounting holes with holes in bracket. Apply upward pressure to console and secure using (2) two #8 x 3/4" screws (item 2 pg 2). See Fig. 12.

17.Tighten (2) two 6-32 X 3/4" screws previously

installed in step 14.

FIGURE 12

7