I. PREPARATION OF VEHICLE INTERIOR
1. Remove and retain O.E. dome light by gently prying downward on rear edge of lens then slide frame assembly out. Disconnect wiring and lay dome light in a safe place. See Fig. 1.
FIGURE 1
2.Using the front edge of dome light opening as a reference location, carefully measure & trim headliner as shown. Caution: Before cutting headliner material, check for wiring or other componentry above headliner. Cut only where indicated. Make sure that the 7" cut is centered left to right in vehicle. See Figure 2. DO NOT
OVERCUT HEADLINER.
3.Scribe a center line on the sheet metal roof of
the vehicle in front and rear of openings in headliner. This will be used for bracket alignment. See Figure 2.
FIGURE 2
4. Install mounting bracket (item 6 pg. 2) with the bent edges upward. Slide bracket rearward until rear tabs engage rear O.E. roof brace. Align notches in bracket with center lines scribed on roof. See Fig. 3 and Fig. 4.
5. Secure front of bracket to front roof brace using
(2) two # 10 X 1/2" screws (item 1 pg 2).
FIGURE 3
3
