Audiovox ACD-13 Error Code / Operating, CD Player Error Codes, Setting the Clock, INSTRUCTI0NS

The correct time-of-day can also be set into the unit by pressing the Time/Frequency Selector button. This procedure is outlined later in these operating instructions.

cq THEFT-DETERRENT LED

Located on the chassis behind the front panel, a light-emitting diode (LED) will flash when the panel is physically removed. The flashing lightserves as a visual warning to the would-be thief that the unit has been disabled by removal of the front panel.

cr RESET BUTTON

A Reset button is located on the front panel of the unit in the extreme lower right corner. The Reset function is provided to protect the microproces- sor circuitry and should only be activated under the

following circumstances as it will erase the time memory:

1. Upon initial installation after all wiring is completed.

2. If there is a malfunction of any of the switches on the unit, pressing the RE SET button may clear the system and return to normal operation.

cs PANEL RELEASE (REL) BUTTON

This button () is used to release the mechanism that holds the front panel to the chassis. To detach the front panel, press the button so that the right side of the panel releases outward. Grasp the panel at the right side and disengage it from the left side of the chassis. To re-attach the panel, engage the left side onto the chassis; then gently press in the right side until it clicks and locks into place. place.

ERROR CODE / OPERATING

CD PLAYER ERROR CODES

If a problem should develop while operating the CD player, an error code (ER-1, ER-2, ER-3, etc.) may appear on the display panel. This can indicate a number of problems with the unit, includ- ing a mechanical error or an error in the microprocessor control of the player. If an error code should appear, try ejecting and reloading the disc into the player. While the disc is out of the unit, make sure it is clean, undamaged, and loaded correctly (label surface up). You may also try activating the RESET button cq on the unit, but this will also erase the time memory.

If the suggested measures do not solve the problem, contact an approved warranty station near you for further assistance.

SETTING THE CLOCK

1.Turn the vehicle ignition and radio on.

2.Press and hold the Time/Frequency button cp for approximately 2 seconds; the time display will begin to flash.

3.Within 5 seconds of selecting the flashing display, press the VOL + button to adjust the hours and the AM/PM indication to the desired setting.

4.Press the VOL - button to adjust the minutes to the desired time.

4.Five seconds after the last hour or minute adjustment is made, the time will be set in the unit and normal operation will resume.

INSTRUCTI0NS

11

128-6496

11 of 16