ARMING THE SYSTEM - PASSIVE ( AUTOMATIC )
1.Turn off the engine, exit the vehicle, close and lock all doors, hood lid and trunk lid.
þRed dash mounted LED begins to flash rapidly, indicating 30 second passive arming has begun.
2.Opening any protected entry point during the 30 second passive arming cycle will imme- diately suspend automatic arming, and the 30 second passive arming cycle will restart when all doors are closed. At the end of the passive arming cycle;
þRed dash mounted LED begins to flash slowly.
þParking Lights flash one time.
þSiren sounds one chirp
If the siren did not sound when arming, then the chirps have been turned off and you should refer to the section titled “ELIMINATINGTHE ARM / DISARM CHIRPS “ in this manual.
oDoors Lock - Optional
Door locking during passive arming is a selectable feature. The alarm can be programmed to allow the doors to lock only when
arming using the keychain transmitter, and they will not automatically lock during passive arming.
PROTECTION WHILE THE SYSTEM IS ARMED
þOpening any protected door, hood, or trunk lid will cause the alarm to immediately sound. The alarm will continue to sound for 30 seconds, then stop and continue to monitor all protected entry points. If the thief left a door opened, the alarm will sound for six 30 second cycles, remain armed and ignore that triggered zone.
þWhenever the system is armed, the red dash mounted LED indicator will slowly flash. This serves as a visual deterrent to the potential thief. The LED is a very low current bulb, and will not cause the vehicle’s battery to drain, even when left unattended for extended periods.
þWhenever the system is triggered, the vehicle’s parking lights will flash for the full 30 second alarm cycle, attracting visual attention to the vehicle.
oOptional - Whenever the system is armed, the vehicle’s starting circuit will be bypassed. If the thief should choose to ignore the siren, the vehicle can not be started.
þAny mild impact to the vehicle’s glass will cause the alarm to sound a short series of warning tones.
þAny strong impact to the vehicle’s glass will cause the alarm to trigger for the full 30 second alarm cycle.
DISARMING THE SYSTEM
1.As you approach the vehicle, press and release the Unlock button on the keychain trans- mitter.
þRed dash mounted LED turns off.
If passive arming was selected during the installation, then the LED will start flashing rapidly, indicating that the system is
Page 3
128-6538
3 of 10
