4AM ANTENNA TRIMMER
It is very important to adjust the Antenna Trimmer for optimum AM reception. The antenna trimmer is located on the right side of the chassis. Adjust it as follows:
1.Tune in a weak station around 1400 KHz on the AM band.
2.Using a small screwdriver, slowly adjust the trimmer for maximum output from the radio.
NOTE: The Antenna Trimmer only affects AM reception, and will have no effect on FM reception. The Trimmer only needs to be adjusted when the radio is first installed and at any time a change is made to the vehicle antenna (replacing the mast, etc.).
5FM LOCAL/DISTANT SELECTOR
This selector switch is incorporated to allow maximum reception in both weak and strong FM signal areas. For normal reception conditions and when receiving a wide range of signals including weak or distant stations, the switch should be set to the “in” position, which will allow maximum signal to the receiver. When in an extremely strong (local) signal area, set the switch to the Local setting (“out” position). This will eliminate weak signals and suppress overly strong signals so as to avoid over- loading the receiver input. When moving out of the strong signal area, return the switch to the Distant (in) setting.
NOTE: The Local/Distant Selector only affects FM sig- nals, and will have no effect on AM reception.
6CASSETTE DOOR
Hold the cassette with the exposed tape edge to the right and insert it into the cassette door. Depress fully until the cassette is engaged and begins playing.
NOTE: Observe the cassette operation cautions in the Care and Maintenance section of this manual.
7FAST-FORWARD/EJECT BUTTON
This button performs two functions. To eject a cassette, simply depress the button fully then release. The cas- sette will eject and radio operation will resume.
To
NOTE: Never leave a cassette engaged in the player when not in use. Doing so can cause damage to the cassette and/or mechanism of the unit. Al- ways press the eject button and remove the cassette when leaving the vehicle.
128-5046A
3 of 28
