OPERATION
2 | 1 |
| 4 | 3 |
| 6 |
| 5 | |
|
|
| 4CH | 2CH |
| ||||
|
|
|
|
|
|
| |||
| PWR |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 4CH | 1CH |
|
| PRT | FULL | LPF |
|
|
| 3CH 2CH | FULL | LPF |
|
|
| 50Hz 250Hz | MIN |
| MIN | GND |
| 50Hz 250Hz |
|
|
| MAX | MAX |
| ||||
|
|
| LPF | GAIN | GAIN |
| LPF | ||
|
|
|
|
| 3CH | 1CH |
|
|
|
CH1CH2
BRIDGED
CH3CH4
BRIDGED
7
FUSE
BATT REM GND
After initial
1Power Indicator Lamps
The Power Indicator Lamps will light to indicate that the unit is connected to the battery and that the Remote
2Protection Mode LED
This LED illuminates red to indicate that the
If activated by a rise in emperature, the unit will resume operation after cooling off to a normal operating range. If activated by an overload condition, the source of the overload must be found and corrected to resume operation of the amplifier.
Most overload conditions are caused by
3Level (Gain) Controls
The amplifier is capable of operating from sources supplying a wide range of input levels. The Level controls should initially be set to the
If it is found that there is not enough output even when the volume control on the car stereo is at its maximum setting, adjust the Level control to increase the output