cordless telephon~ -to the nationwide
telephone network tMough a modular
telephone jack (USOC ~J11C or RJ11W).
Your telephone company may discontinue
your service if your equipment causes harm
to the telephone network. They will notify
you in advance of disconnection, if possible.
During notification, you will be informed of
your right to file a complaint with the FCC.
If it is determined that your telephone
equipment is malfunctioning, the FCC
requires that it not be used and that it be
unplugged from the modular jack until the
problem has been corrected. Repairs to this
telephone equipment can only be made by
the manufacturer or its authorized agents or
by others who may be authorized by the
FCC. For repair procedures, follow the
instructions outlined under the AUDIOVOX
Limited Warranty.
The REN is useful in determining the
number of devices you may connect to your
telephone line and still enable the devices
to ring when you receive a call. The general
rule is that the REN value should not exceed
5.0A total; however, contact your local
telephone company for the specific number
in your area.
INDUSTRY CANADA (IC) NOTICE
NOTICE: The Industry Canada (IC) label
identifies certified equipment. This certifi-
cation means that the equipment meets tel-
ecommunications network protective, opera-
tional and safety requirements as prescribed
in the appropriate Terminal Equipment Tech-
nical Requirements document(s). The de-
partment does not guarantee the equipment
will operate to the user satisfaction.
Before installing this equipment, users
should ensure that it is permissible to be
connected to the facilities of the local tel-
ecommunications company. The equipment
must also be installed using an acceptable
method of connection. The customer should
be aware that compliance with the above
conditions may not prevent degradation of
.:;.-
~
States. It also complies with regulations
-RSS-21 O and CS-03 of Industry Canada (IC).
A label is located on the underside of the
base .;.unit containing both the FCC
registration number and Ringer Equivalence
Number (REN) or the IC registration number
and Load Number. You must, upon request,
provide this information to your local
telephone company.
This equipment is compatible with
inductively coupled hearing aids.
FCC Part 15
Warning: Changes or modifications to
this unit not expressly approved by the party
responsible for compliance could void the
user authority to operate the equipment.
The equipment has been tested and found
to comply with part 15 of the FCC rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in
a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try and correct
the interference by one or more of the
following measures:
.Reorient or relocate the receiving antenna.
.Increase the separation between the
equipment and receiver-
.Connect the equipment into an outlet or
on a circuit different from that to which
the receiver is connected.
.Consult the dealer or an experienced ra-
diofTV technician for help.
FCC Part 68
The FCC requires that you connect your
=fl