UP and DOWN Buttons:

If these buttons are pressed before pressing the Lock/function button, a single press will display the current volume setting and subsequent presses will change the volume setting up or down.

Important: If a speaker/microphone or earphone is used, check the volume setting before connecting it to the earphone jack. Be sure to set the volume low at first, and then raise it to a comfortable level.

Lock/Function Button:

The Lock button allows the user to eliminate the possibility of accidentally changing the transceiver’s selectable functions. Pressing and holding this button for two seconds will activate the lock function. “LOCK” will be displayed in the lower right of the display, indicating that the settings are locked in. While in the lock mode, it is still possible to adjust the volume, however other settings will be fixed. To unlock the transceiver simply, press and hold the lock button for 2 seconds. While the unit is unlocked, you may change any of the adjustable features by following the instructions that follow.

PTT (Push To Talk) Button:

Pressing and holding this button will allow you to speak to any transceiver that is set to the same channel and privacy code setting as yours. Hold the transceiver approximately 3 to 5 inches from your face as you speak. After you have finished speaking, release the PTT button to allow the reception of incoming signals. It is not possible to transmit and receive at the same time. “ON AIR” will show on the left side of the display and the red LED to the left of the display will illuminate while the PTT button is pressed.

Low Battery Warning:

“BATT LOW” will show in the upper right hand corner of the display as a warning of low battery voltage. As the batteries become weak only the word “ON” instead of “ON AIR” will show on the display when the PTT button is pressed.

Signal Strength Indicator (SSI):

The six dashed lines ------ on the lower left of the display indicate the strength of incoming

signals. Six lines represents a strong signal. One line indicates a weak signal. While receiving a signal, one to six lines will be displayed indicating the strength of the signal. While pressing the PTT button the signal strength indicator represents the strength of the signal being transmitted.

4

128-5379C

5 of 12

Page 5
Image 5
Audiovox FR-214 warranty UP and Down Buttons, Lock/Function Button, PTT Push To Talk Button, Low Battery Warning