Operating Modes and Features

GMRS Operation:

-From GMRS/FRS standby mode, press and hold the ( ) button for 2 seconds to turn on power.

-Press the MODE button so the Channel number flashes.

-Select the desired channel with the Up (10) and Down (11) Buttons. When receiving a call, the BUSY icon appears to indicate the incom- ing signal.

-Press and hold the PTT button (4) to transmit, then speak into the microphone clearly and slowly. The Transmit Signal Level indicator

( ) will display the relative strength of the transmitted signal.

-Release PTT Button (4) to receive.

-Communication can only be accomplished when the channel and CTCSS tone frequency of at least two parties are the same.

-The CTCSS small segment display will appear next to the main frequency channel on the display if the CTCSS tone frequency function is enabled.

Channel Selection

In order to communicate with other GMRS units, both transmitting and receiving party must be on the same frequency. The GMRS7001-2 has 22 channels (frequencies) indicated by the large digits on the LCD display panel. Channels 1 through 7 are the shared GMRS/FRS channels. Channels 8-14 are FRS only channels, while channels 15-22 are as- signed GMRS only channels. If an FRS only channel (8-14) has been selected, the HI or LO indicator will not be displayed on the LCD panel; otherwise, for channels 1-7 (GMRS/FRS) and 15-22 (GMRS only), the HI or LO indicator will be displayed. Communication with Audiovox FRS and compatible units is possible on the shared and FRS only channels. Before transmitting on the selected channel, press the Monitor (M) Button

(2)to check the activity on that channel. If there is activity on the selected channel, change to another channel that is clear.

10

128-6730

10 of 24

Page 10
Image 10
Audiovox GMRS70012 owner manual Gmrs Operation, Channel Selection