CONNECTIONS & SETUP
This part of the setup allows the TV to search for all channels viewable through your antenna or
cable TV system. This is called auto channel search.
1. Make sure the remote is in the TV mode by pressing the TV button.
2. Press MENU (the Main menu appears).
3. Press the down arrow button until SETUP is highlighted, and press ENTER (the SETUP menu
appears).
4. Press the down arrow button until ANTENNA INPUT is highlighted, and press ENTER (the
ANTENNA INPUT menu appears).
5. Press the down arrow button to highlight AIR (for an off-air antenna) or STD, HRC, or IRC
(cable systems) depending on the type of signal you have. Then press ENTER.
NOTE: Contact your cable company if you’re not sure which system you have.
6. Press MENU again (the Main menu appears); press ENTER to select the SETUP menu.
7. Press the down arrow button until AUTO CH. SEARCH is highlighted, and press ENTER to
begin the auto channel search. This may take several seconds.
Remark: You can also program the available channels by pressing the Auto CH. SEARCH button
on the remote.

Complete Auto Channel Search

MAIN MENU
CLOSED CAPTION
PICTURE
ZOOM MODE
PARENTAL CONTROL
SETUP
SETUP
WRITE
ERASE
AUTO CH. SEARCH
ANTENNA INPUT
ANTENNA INPUT
AIR
STD
HRC
IRC
ENTER
ENTER
15