MP6512i

WIRING

NOTE: The amplifier in this radio is only designed for use with four speakers. Never combine (bridge) outputs for use with two speakers. Never ground negative speaker leads to chassis ground. Failure to wire exactly as shown may cause electrical damage to the radio.

NOTE: Only connect speakers with a nominal impedance of 4 ohms. Speakers with a load impedance less than 4 ohms could damage the unit.

DATA BUS

DATA BUS

SAT L SAT R SAT

Ground

Connect to ground terminal or clean, unpainted part of chassis.

3.5mm

Audio Only

Black

Memory/Battery

Connect to battery or 12 volt power source that is always live. The radio will not work if this wire is not connected.

Yellow

FRONT SP

Rear Line out

R (Red)

Gray

L (White)

Front Line out

R (Red)

Black

L (White)

Power Antenna

Connect to power antenna or amplifier. If not used, tape bare end of wire.

Blue

Accessory/Ignition

Connect to existing radio wire or radio fuse.

Red

REAR SP

White/Black

White Gray/Black

Gray

Green/Black

Green Purple/Black

Purple

Stripe

Stripe

 

Stripe

Stripe

 

iPod Video

iPod

 

 

 

iPod Mini iPod Nano

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

jLink iPod Cable

Left Speaker

Right Speaker

Left Speaker

Right Speaker

(Sold Separately)

(Front)

(Front)

(Rear)

(Rear)

 

5

Page 9
Image 9
Audiovox MP6512i operation manual Wiring, Memory/Battery