Audiovox P-49 Bl AM/FM Band Selector Band, Bm TUNE/SEEK / Buttons, Bq Station PRE-SET Memories

mute the audio; however, cassette and/or changer play will continue and not be paused.

bl AM/FM BAND SELECTOR (BAND)

Each time the BAND/LOU button is pressed momentarily, the radio band is changed. The indication AM, FM1, FM2 or FM3 will appear on the display panel according to your selection.

bm TUNE/SEEK ( / ) BUTTONS

To manually select a radio station, momentarily press the Up Tuning

( ) button to advance the unit higher, or the Down Tuning

( ) button to tune lower within the selected band.The radio will tune to the next available station. Pressing either button for longer than 0.5 second will cause MANUAL to appear on the display; in this mode each press of the TUNE/SEEK button will increase or decrease frequency in 200 kHz steps. Pressing and holding either button in the MANUAL mode will cause the radio to rapidly tune in the upward or downward direction, and stop when the respective button is released. Five seconds after tuning is complete, AUTO will momentarily appear.

by the ST indication on the display panel when tuned to an FM stereo signal. If the stereo signal is too noisy for comfortable listening, press the MON button to switch to mono reception (the ST indication will disappear from the display panel, and MONO will be displayed). To return to stereo reception mode, press the button again so that the ST indication reappears in the display.

bp LOCAL STATION SCAN (SCAN) BUTTON

Press this button momentarily to commence a scan of the nearby local stations whose signal strengths are the strongest (the station number will appear flashing on the display panel during station search). Press the button again momentarily to stop the Scan operation and remain on the current local frequency. To return to one of the frequencies preset into the current band, press the desired pre-set button.

bq STATION PRE-SET MEMORIES

To set any of the 6 pre-set memories in each band, use the following procedure:

bn LOCAL (LOC) BUTTON

This feature is used to select the strength of the signals at which the radio will stop during Automatic Seek Tuning. Pressing and this button will select the Local setting (LOCAL will appear on the display panel) and only strong (local) stations will be received. Pressing the button again will select the normal Distant setting (LOCAL will disappear from the display panel, and Dx will be displayed instead) and the radio will stop at a wider range of signals, including weaker (more distant) stations.

bo FM MONO/STEREO BUTTON (MONO)

During FM radio operation, this button is used to select mono or stereo reception of the broadcast signal. Under normal reception conditions, the unit should be left in the stereo mode as indicated-5-

1.Turn the radio on and select the desired band.

2.Select the first station to be pre-set using the Manual TUNE or Automatic SEEK Controls bm .

3.Press the pre-set button to be set and continue to hold it in for approximately 2 seconds. The preset number (1-6), will appear on the display panel indicating that the station is now set into that preset memory position. The station can now be recalled at any time by pressing that button.

4.Repeat the above procedure for the remaining 5 pre-sets on that band and for the other 3 bands on the unit.