ct REMOTE SENSOR
The sensor for the infrared signal from the wireless remote
control is located behind this lens. For optimal operation of the
remote control, always aim it toward the sensor.
cu THEFT-DETERRENT L.E.D.
Located on the chassis behind the front panel, a light-emitting
diode (L.E.D.) will flash when the panel is removed. The flashing
light serves as a visual warning to the would-be thief that the unit
has been disabled by removal of the front panel.
dl RE-SET BUTTON
A Re-Set button is located on the front of the chassis (front panel
must be removed to access the button). The re-set circuitry is
provided to protect the microprocessor circuitry and should only
be activated under the following circumstances as it will erase
the time and pre-set memories.
1. Upon initial installation after all wiring is completed.
2. After the position of the frequency step switch on the bottom of
the chassis has been changed.
3. If there is a malfunction of any of the switches on the unit,
pressing the Re-Set button may clear the system and return
to normal operation.
dm FRONT PANEL RELEASE BUTTON
Pressing this button will cause the front panel to drop down to the
lowered position so a disc may be loaded or ejected or so that the
panel may be detached. To detach the front panel, press the
button so that the panel is lowered and then grasp the middle of it
and pull it off of the chassis. To re-attach the panel, position it
-6-
Track Scan mode will also be canceled by activating the Repeat
Play co, Shuffle Play cp, or Track Select cl functions.
cr DISC EJECT ( )
Disc play is stopped and the disc is ejected by pressing this
button on the rear of the front panel. Radio, CD changer or AUX
operation will automatically resume depending on which mode
was in operation prior to disc play. If the disc is not removed from
the unit and the button is pressed again, the disc will be re-loaded
and begin playing.
If the disc is not removed from the disc slot within 10 seconds of
being ejected, it will automatically be re-loaded into the unit to
prevent it from being accidentally damaged. Play of the disc can be
resumed by using the Mode Selector bt to choose CD player
function.
cs TIME/FREQUENCY SELECTOR (T/F)
This unit can be set so that either the clock time or radio
frequency/CD functions will normally appear on the display panel.
Pressing the Time/Frequency Selector button when the radio
frequency or CD indication is shown will change the display to
show the time. The time will then be the priority setting and the
display will automatically return to time display 5 seconds after
any other radio, CD, or audio function display.
If the unit is set to time display priority, pressing the Time/Frequency
Selector button will change the display to show the radio
frequency/CD/AUX indication and this will then become the
priority setting to which the display automatically returns 5 seconds
after any other function is activated.