Routing Speaker Wires
Route the speaker wires as follows:
1.Route speaker wires from stereo into door. If possible, use existing wires. If door is not equipped with grommets, drill a 1/4” hole in door edge and door frame.
2.Connect wires to speaker per stereo wiring instructions. Allow enough slack between door edge and frame to fully open door. DO NOT tape wires to hinges or braces.
3.Place speaker into door and secure using screws (and clips, if necessary) provided with speaker.
4.Test the speaker. Then install grille (grille snaps over outer ring of speaker frame). Repeat for remaining door.
4
3
2
1
| Routing Speaker Wires | Securing Speaker and Grille | ||
1. | Door Frame | |||
|
| |||
2. | Kick Panel |
|
| |
3. | Connect speaker wires to speakers | 1. | Mesh Grille | |
4. | Route wires to stereo | |||
2. | Speaker mounting screws | |||
5. | Drill 1/4” hole or use existing grommets | |||
3. | Speaker | |||
6. | Door (open) | |||
4. | Grille | |||
|
| |||
128-6825
8 of 10
