VOD285

1)Make the connections to the vehicle for the 12 pin wiring harness.

2)Connect power harness to vehicle’s electrical system by tapping into an accessory hot line and a good ground.

3)Connect the 12 pin harness to the mating connector on the Video Monitor.

4)If an auxiliary video input is used (VCP, DVD, etc) insert the Circular Mini-Din Connector of the source component harness through the wire tie loop on the main PCB and into the Mini-Din Connector on the main PCB.

5)Pull the wire tie loop tight and cut off the excess.

Note: A VCP or other A/V Component can be connected to the video monitor system using a source

component harness (purchased separately, part number: 8010730). This harness plugs into the Mini-Din connector on the main PCB as in steps 4 and 5 above.(See Figure A on previous page)

6)Verify all functions of the System before final mounting of the finished assembly.

7)Mount and connect the Television antenna. (Optional)

A/V Source Definitions:

1.DVD1 – Built in DVD

2.DVD2 – Built in DVD

3.AV1 (DIN1)

4.AUX/Game

5.AV2/ TV – When PODTVT is used the AV2 input position becomes inactive (DIN2).

*NOTE: If the optional relay box P/N SIRSWB is installed, it recommended that the antenna for the wireless FM Modulator be unplugged. See VOD285 Wiring Diagram for antenna location.

**NOTE: Extending the wireless antenna beyond its 12 inch length will cause the FM Modulator to exceed FCC limits for wireless transmission. When installing the unit position the antenna for best reception.

***NOTE: If the optional TV Tuner (P/N PODTVT) is installed the AV2 (DIN2) input becomes inactive.

7

Page 9
Image 9
Audiovox VOD285P, VOD285S manual