Audiovox VOD806 owner manual

VOD806

Hard Wired FM Modulator Output

TO

FACTORY

RADIO

	Am/Fm
	Antenna	FM
Dash Radio		Modulator
			FM Modulator

8 Pin Modulator

Hardness

Red: +12VDC	Power Harness
(Accessory Cir.)
		Mini-Din Connectors
	Choke
Black: Ground
	Dom e Light Connection.
	Refer to Connecting the
	Dom e Lights	1
		TV antenna
		(If applicable)
		LEFT
		WHITE
	For Receivers with Low Level Audio Input
		RIGHT
		RED

	To Secondary AV Monitor
						A ccessory
						H arness
TO		INPUT	RCA-Female
	12 VDC Power and Ground
OPTIONAL		VIDEO
					12 Pin Power signal
ADDITIONAL	Auxillary			LINE
			Patch Cord	OUT	Harness	Red RCA (Audio Right)
MONITOR	video display			VIDEO
			RCA Male to Male			White RCA (Audio Left)
						Yellow RCA (Video)

		Power Connector	“Y’ Adapter
		4 Pin	for use with
			Installations
Optional Remote Headphone Stations		IR LED:
		Clean the IR
		Receiver Window
Stereo	Green	on the front of the
		VCP. Remove
Headphone Jack	(Right+)
		Adhesive Backing
		and Apply IR LE	￿ #8￿ )
Stereo	Black	to IR Window on
		the Face of the VCP.	CH-3
	(Ground)		,+￿￿ 8
Headphone Jack			CH-4
			Out
	Gray
	(Left+)

1)Make the connections to the vehicle for the 12 pin wiring harness.

2)When connecting an AV Component, insert the Circular Mini-Din Connector of the source component harness through the wire tie loop on the main PCB and into the Mini-Din Connector on the main PCB. Pull the wire tie loop tight and cut off the excess.

3)Connect power harness to vehicle electrical system by tapping into an accessory hot line and also a ground.

4)Connect 8 pin wiring harness from video monitor to the mating connector on FM Modulator.

5)Connect the FM Modulator to the Vehicle Radio.

6)Mount and connect the Television Antenna (sold separately).

7)Verify all functions of the System before final mounting of the finished assembly.

A/V Source Definitions: 1= TV Tuner

2= AV1 input (VCP, game or future DVD, etc) 3= AUX input (VCP, game or future DVD, etc) 4= Built -in DVD

-6-