Audiovox VOH701 manual

Power Connector 4 Pin

VOH701

TO FACTORY RADIO

				Dome Light
				Item #6
Red: +12 VDC		Power Harness
		Item # 3
(Accessory Cir.)
Black: Ground
		Optional Hard Wired FM Modulator Output
12 VDC Power and Ground			Left	RCA-Female
Am/Fm		FM	Input
Antenna
		Modulator		Patch Cord
		1070610		RCA Male to Male
Dash Radio			Right
	*Refer to Instructions with the RF
	Modulator Kit for further details.		Input	RCA-Female

Note: cables exiting the pod should be routed as shown.

Mini-Din Connectors

1 2

LEFT

WHITE

RIGHT

REDAccessory Harness

Item#2

Red RCA (Audio Right)

White RCA (Audio Left)

Yellow RCA (Video)

IR LED:

Clean the IR Receiver Window on the front of the VCP. Remove Adhesive Backing and Apply IR LED to IR Window on the Face of the VCP.

"Y" Adapter for use with Non-Stereo Installations Item# 5

1)Make the connections to the vehicle for the 2 pin wiring harness.

2)Insert the Circular Mini-Din Connector of the source component harness through the wire tie loop on the main PCB and into the Mini-Din Connector on the main PCB.

3)Pull the wire tie loop tight and cut off the excess.

4)Connect the wired RF Modulator and / or the remote headphone jacks to the video monitor if those options are being included.

5)Connect power harness to vehicle’s electrical system by tapping into an accessory hot line and a good ground.

6)Verify all functions of the System before final mounting of the finished assembly.

Note: A second VCP or other A/V Component can be connected to the video monitor system using a

second source component harness (purchased separately, part number: 8010730). This second har- ness would plug into the second Mini-Din connector on the main PCB as in steps 2 and 3 above.

A/V Source Definitions:

1= VCP (Right Mini-Din on main PCB)

2= 2nd VCP (or game or DVD, etc.…. left Mini-Din)

3= AUX-INPUT (RCA jacks on the face of the monitor).

-6-