WHS100
Audiovox Wireless Infrared Headset
System Installation Instructions
Parts supplied
1.IR transmitter (1)
2.IR Transmitter harness (1)
3.IR headphones (2)
Notes:
• | For best results, IR transmitter must be installed as |
| shown with the LED’s pointing toward the rear of the |
• | vehicle (Fig. 1) |
Audio input can be connected to either a | |
| fixed audio output or a variable level audio output |
Fig. 1
TRANSMITTER POSITIONING DIAGRAM
TRANSMITTER
FRONT | REAR |
POSITION JUST ABOVE THIGH AREA OF SECOND
(such as a speaker or headphone output). If it is |
connected to a |
control on the headphones needs to be adjusted to |
control volume level. If connected to a variable level |
output, volume adjustment needs to be done at both |
Fig. 2
PASSENGER ROW SEATING
WIRING DIAGRAM
the source and at the headphones. |
Wire harness with RCA connectors (Fig. 2).
1.Using dual RCA (M/M) cable (not supplied, length determined by installation) connect one end to red and white RCA jacks. Connect the other end to low level signal source.
2.Connect pin 4 (black wire, negative) to ground of vehicle.
3.Connect pin 5 (red wire, +12 volt) to ignition source (source that supplies +12 volts when the ignition is switched on).
1. GROUND |
| 1. LEFT RCA CHANNEL IN |
2. WHITE |
| 2. RIGHT RCA CHANNEL IN |
| ||
3. RED |
| |
|
| |
4. BLACK |
| 3. DC 12V GND – (NEGATIVE) |
5. RED |
| 4. DC 12V IN + (POSITIVE) |
|
|
Fig. 3 | |
|
CEILING OF THE CAR
FACE LEDs TOWARDS REAR OF VEHICLE
IR Transmitter
1.Plug wire harness into transmitter.
2.Remove lens on transmitter to expose screw holes (Fig. 3).
3.Fasten transmitter to headliner using two short screws (make sure that screws do not puncture metal of roof).
Wireless headphones
1. Follow directions in owner’s manual for proper
operation. | SIDE VIEW | TOP VIEW |
© 1998 Audiovox Corp., Hauppauge, N.Y. 11799 |
