Audiovox WHS250 warranty Fig, 2 3 6, Channel Separation 45 dB

INTRODUCTION

CONGRATULATIONS on your purchase of the the state-of-the-art Dual Channel Stero Automotive Infrared Stereo Headphone System from Audiovox Corporation. This system frees you from the tangle of headphone wires and lets you enjoy music or video without the tangle of cables around you. To ensure the best performance of your system, please read this manual carefully.

SPECIAL FEATURES

Dual Channel.

Automatic Level Control prevents input signal over loading.

Uses high frequency infrared light to assure a clean signal for clear reception.

EXPLANATION OF CONTROLS (Fig. 1)

Infrared Transmitter

1. INFRARED LED TRANSMITTERS – Sends signals to headphones. Permits connection to two stereo sources, providing simultaneous

transmisssion of both stereo signals.

Headphone Receivers

2.INFRARED PICKUP SENSORS – Receives signals from transmitter.

3.BATTERY COVER

4.VOLUME CONTROL

5.POWER SWITCH

6.POWER INDICATOR LED

7.Channel A/B Switch

8.AUTO ON/OFF MICRO SWITCH

Fig. 1		R
	L

2 7

3

6

5

4

Auto ON/OFF

8 Micro Switch is activated when headphones are placed on head

BATTERY INSTALLATION (Fig. 2)

1.Place two alkaline AAA batteries in the Headphones(s) battery compartment making sure that the battery polarity is correct.

Operation

Please Read Carefully to Prevent Damage to the Headphones or your Ears:

WARNING: Before switching between channels A and B, remove headphones and turn the volume

Fig. 2

setting to a low setting as it is possible that the signal of one channel could be louder than the other.

1.Be sure batteries are properly installed in the headphones.

2.Turn the headphone volume nearly off before turning on the power. Turn on the headphone power then increase the headphone volume to a comfortable level. You can increase the source audio volume if necessary (when connected to a variable audio source such as a headphone source).

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

Product Specifications: Operating range: up to 25 Ft. Frequency Response: 35 – 18,000 Hz S/N ratio: 60 dB

Channel Separation: 45 dB