Aussie 7110.7.641 manual Assemble Hood/Bowl to Cart

Step 3) Assemble Hood/Bowl to Cart:

(15) BOLT, M6X45

4 PC

(14) HOOD/BOWL ASSEMBLY

NOTE: REQUIRES 2-PERSONS

·With Cart upright, align Bowl Bracket legs with Cart legs. (FIG. 3A)

·Lower Hood/Bowl so ends of Cart legs insert into Bowl Bracket legs.

·Press downward until leg screw holes align. NOTE: If cart legs do not align and fit into Bowl Bracket legs easily, loosen the Control Panel bolts slightly. Then open the Hood and loosen the 2-Bowl/Leg bolts on either, or both sides of the Bowl. (FIG. 3B)

·Insert M6x45 Bolts from the outside through the legs and tighten with M6 Locknuts. (FIG. 3C)

·Re-tighten all Bolts.

View Inside Bowl

Bowl/Leg Bolts

Left and Right

Sides

FIG. 3B

(16) M6 LOCKNUT

4 PC

Bowl Bracket Legs

Control Panel Bolt on each side of grill

FIG. 3A

(15) M6 Nut

(16) BOLT, M6X45

FIG. 3C

Step 4) Install Drip Cup:

Insert Drip Cup into Drip Cup Holder ring (installed in bottom of Grill Body) until the cup flange is flush with the ring

(17) DRIP CUP

7