Autonet MINIVAN, K6860631 manual CAUTION Do not use acid core solder

2

6.Secure the Wi-Fi Router under the passenger seat (1) with the supplied tie straps and Velcro® tape (3).

7.Connect the power harness connector (2) to the Wi-Fi router.

NOTE: Do not use the power outlet for the power supply to the Wi-Fi router.

8.Locate the keyed power outlet wiring harness.

9.Cut each wire and remove 13 mm (0.5 in.) of insula- tion from each wire that needs to be soldered/spliced.

10.Place a piece of supplied adhesive lined heat shrink tubing on one side of each cut wire. Insure the tubing

will be long enough to cover and seal the entire sol- dered area.

CAUTION: Do not use acid core solder.

11.Solder the supplied fused pigtail to Wi-Fi power har- ness power wire.

12. Place the strands of the power side wires overlapping each other inside of the splice clip (1 ) along with the red fuse holder wire(2).

K6860631 Rev. 1

March 24, 2009