Avalon Acoustics OPUS Ceramique Loudspeaker Wiring Instructions, Do NOT over-tightenthe screws

3 Wiring Instructions

Introduction

The crossover is housed in a sealed, non-accessible chamber in the bottom of the speaker cabinet, to minimize the effect of vibration on the components. The Opus Ceramic is equipped with high-quality barrier terminals for connecting the speaker cables. Ring terminals or spade lugs designed for #10 screws are recommended for cable termination.

Connecting the Speaker to the Amplifier

1.Place the speaker in its approximate location, then lay the speaker on its side, using a soft surface to avoid scratching the finish.

2.Connect the speaker wires to the terminal block on the speaker bottom (see Figure 3.1). Check to insure the correct polarity (positive lead connected to the (+) terminal and negative lead connected to the (-) terminal.

Do NOT over-tighten the screws.

3. Stand the speakers up.

11