
3 Wiring Instructions
Introduction
The crossover is contained in a
Connecting the Speaker to the Amplifier
1.Place the speaker in its approximate location, then lay the speaker on its side, using a soft surface to avoid scratching the finish.
2.Connect the speaker wires to the terminal block on the speaker bottom (see Figure
3.1). Check to insure the correct polarity (positive lead connected to the (+) terminal and negative lead connected to the
Do NOT overtighten the screws.
From Amplifier
Figure 3.1 - Bottom view of the speakers showing the connections from the amplifier to the loudspeaker. Check to insure the correct polarity (positive lead connected to the (+) terminal and negative lead connected to the
3. Stand the speakers up.
7