Avanti BCAD353 instruction manual  ON/OFF Power,  Storage

Models: BCAD353

1 20
Download 20 pages 12.89 Kb
Page 10
Image 10

OPERATING YOUR BEVERAGE COOLER

IMPORTANT SAFEGUARDS

Do not store food in Beverage Center, as interior temperature may not get cool enough to prevent spoilage.

As a natural result of condensation, in summer months or areas of high humidity, the glass door may build up moisture on the outside. Just wipe it away.

It is recommended you install the appliance in a place where the ambient temperature is between 72- 78 ºF (22º - 26ºC). If the ambient temperature is above or below recommended temperatures, the performance of the unit may be affected. For example, placing your unit in extreme cold or hot conditions may cause interior temperatures to fluctuate. The range of 34º-43ºF (1º-6ºC) may not be reached.

Your Beverage Cooler is designed to operate with at a range of 34º - 43º F (1 – 6ºC).

Attention

This unit is equipped with a power delay system to protect the compressor in the event of a power outage.

This power delay system will delay the compressor start cycle for “3” three minutes both at the first time the unit is plugged in and when there is a power outage.

Once the unit is plugged in for the first time or power has been restored to the unit, the compressor will start cycling after (3) three minutes of uninterrupted power supply.

Digital display, LED Lighting and temperature settings will work as normal and not be affected.

ON/OFF POWER

Your unit is designed to turn ON as soon as the power cord has been plugged into an active electrical outlet.

Setting the Temperature Control

Your unit has only one control for regulating the temperature in the compartment. The temperature control is located on the upper left hand side of the compartment.

The range of the temperature control is from “34ºF” to “43ºF”.

The first time you turn the unit on, press the set button and then

press the “DOWN” button to set the temperature to “34ºF”.

After 24 to 48 hours, adjust the temperature control to the setting that best suits your needs; by

first pressing the Set button then, pressing the or buttons .

To turn the off the cooling system, unplug the unit from the electrical outlet.

NOTE:

Also, as cold air falls and warm air rises, there could be a slight temperature variance between the top and bottom shelves.

STORAGE

Many bottles may differ in size and dimensions. As such the actual number of bottles you may be able to store may vary.

10

Page 10
Image 10
Avanti BCAD353 instruction manual  ON/OFF Power,  Storage