Avanti OR2700SS instruction manual Casters Installation Sketch, Before After, Installing Your Unit

CASTERS INSTALLATION SKETCH

?Install the four casters provided into the unit’s bottom four threaded holes supplied . Follow the instructions in the installation sheet located inside the plastic bag that contains the user’s guide.

(I) BEFORE (II) AFTER

Installing Your Unit

?Place your unit on a floor that is strong enough to support the unit when it is fully loaded. To level your unit, adjust the leveling leg at the bottom of the unit.

?Locate the unit away from sources of heat (stove, heater, radiator, etc.). Heat sou rces may increase electrical consumption. Extreme cold ambient temperatures may also cause the unit not to perform properly.

?Avoid locating the unit in moist areas.

?Plug the unit into an exclusive, properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized Avanti Products service center.

?After plugging the appliance into a wall outlet, allow the unit to cool down for 2 -3 hours before placing food in the refrigerator compartment.

Electrical Connection

?Warning?

Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged, have it replaced by an authorized Avanti Products service center.

This unit should be properly grounded for your safety. The power cord of this unit is equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the possibility of electrical shock.

Do not under any circumstances cut or remove the third ground prong from the power cord supplied. For personal safety, this appliance must be properly grounded.

This unit requires a standard 115/120 Volt AC ~/60Hz electrical outlet with three-prong ground. Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded. When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet.

10