CARE AND MAINTENANCE
CLEANING YOUR WINE CHILLER
•Turn off the power, unplug the appliance, and remove all items including shelves.
•Wash the inside surfaces with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart of water.
•Wash the shelves with a mild detergent solution.
•Wring excess water out of the sponge or cloth when cleaning area of the controls, or any electrical parts.
•Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with a clean soft cloth.
•Do not use steel wool or steel brush on the stainless steel. These will contaminate the stainless steel with steel particles and rusting may occur.
POWER FAILURE
•Most power failures are corrected within a few hours and should not affect the temperature of your appliance if you minimize the number of times the door is opened. If the power is going to be off for a longer period of time, you need to take the proper steps to protect your contents.
MOVING YOUR WINE CHILLER
•Remove all items.
•Securely tape down all loose items (shelves) inside your appliance.
•Turn the adjustable leg up to the base to avoid damage.
•Tape the door shut.
•Be sure the appliance stays secure in the upright position during transportation. Also protect outside of appliance with a blanket, or similar item.
ENERGY SAVING TIPS
•The Wine Chiller should be located in the coolest area of the room, away from heat producing appliances, and out of the direct sunlight.
CHARCOAL FILTRATION SYSTEM
Your cellar is equipped with an active charcoal filtration system to ensure air purity, cooling efficiency, and to maintain an odor free cabinet for the storage of your fine wines. The filter assembly is located at the bottom of the rear panel inside your cellar. Keep in mind, that this filter must be changed every 12 months .
To replace your filter:
1 | Remove the bottles of wine stored on |
| the two (2) bottom shelves |
2 | Remove the shelves and set aside to |
| be replaced once you have changed |
| the filter |
3 | Grasping the filter from both the top |
| and bottom edges, pull toward you |
| and remove the entire filter assembly |
| cover. |
4 | Remove the existing filter and replace |
| with a new one. |
5Replace the filter assembly cover by pressing it against the assembly until you hear a “click” sound.
12
