NOTE: Your water dispenser has been cleaned and sanitized before leaving the factory, but in case a taste problem develops, place one tablespoon of baking soda and add tap water. Fill water tank again and repeat basic operations previously outlined.
?WARNING?
IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL SHOCK. IF THE POWER CORD IS DAMAGED, HAVE IT REPLACED BY AN AUTHORIZED AVANTI PRODUCTS SERVICE CENTER.
OPERATING YOUR WATER DISPENSER
Electrical Connection
This appliance should be properly grounded for your safety. The power cord of this appliance is equipped with a
Plug the appliance into an exclusive properly
This appliance requires a standard 115 Volts A.C. / 60Hz electrical outlet with
The cord should be secured behind the appliance and not left exposed or dangling to prevent accidental injury.
Do not use an adapter plug with this appliance.
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified electrician or service technician install an outlet near the appliance.
Steps To Replace Water Bottle
?Use a clean cloth to wipe off neck of bottle.
?Remove cap, if there is one on.
?Insert the water bottle on the water intake over reservoir opening so it settles properly on it.
?Wipe off any water, which may have splashed on dispenser top.
Cold Water Control
Turn the power switch on. The yellow (cool) indicator will be lit and the process begins. When the water reaches the right temperature the yellow (cool) light goes off and the green (cold) light turns on.
CARE AND MAINTENANCE
?Wash the inside of the reservoir with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart of water.
?The drip tray and water faucets should be cleaned with mild detergent and warm water.
7
