To Install Your Wall Telephone

1.Align the wall phone plug with the jack, then line up the hole in the back of the telephone set with the rivets on the wall outlet plate. Push in and slide the telephone down into place (Figure 4).

2.Plug one end of the coiled handset cord into the jack in the handset. Push the plug in until it clicks.

3.Plug the other end of the cord into the jack in the bottom of the wall base. Push the plug in until it clicks.

4.Adjust the ringer volume switch on the upper right side of the telephone to the desired setting.

For All Telephones

Place the number card on your telephone following the instructions on the back of the number card label.

FIGURE 4 Wall Telephone Installation

To Remove Your Telephone

1.To disconnect or remove your telephone reverse the installation procedures. To remove any modular plug, squeeze the clip of the plug and pull it out of the jack.

2.To disconnect a wall set, slide the set up to lift it off the rivets and pull it away from the wall.

5

Page 7
Image 7
Avaya Trimline, Desk manual To Install Your Wall Telephone, For All Telephones, To Remove Your Telephone