1If the HDTV shows video but without audio, please try to set audio mode to stereo
2Factory default:
3If you encounter any unsolved audio/video output problem during system installation, please
turn to Safe Mode (Pin#1- | - |
output for system check. |
|
4Bypass means the matrix will maintain playing the original format of HDMI signals in video and perhaps audio. By setting at this mode, the users may encounter compatibility issue among different kinds of HDMI sources and displays. If you cannot get the audio and/or video output normally at the system installation, please change the DIP switch setting to default mode or even safe mode to verify the functionality of the device.
20 seconds. The EDID learning procedure will be finished. If you want to learn the EDID from another HDTV, you must set Pin#1 at OFF first and repeat this procedure.
1.7.3 HDMI-C5XD-SR Rear Panel
| 1 | 2 | 3 | 4 | 5 |
| 6 | 7 |
|
|
|
|
|
| |||
1. | Input Signal format indicator |
| 2. |
| Rotary Switch | |||
| (Bright: HDMI Single, Dim: DVI Signal) |
|
| |||||
|
|
|
|
| ||||
3. | RJ45 IN: Connect RJ45 Source from |
| 4. | Audio Out: Plug in Local Speaker | ||||
|
|
|
| |||||
|
|
|
|
|
|
| ||
|
|
|
|
|
| 6. HDMI Signal Out: RJ45 connection to | ||
5. | HDMI OUT: | HDMI Local Output |
|
|
| connect to | ||
|
|
|
|
|
|
|
| |
7. | Power Connector: 5V 4A DC |
|
|
|
| |||
|
|
|
|
|
|
|
|
|
1.7.4 HDMI Output Format Selection
When input signal exists, the output format LED turns on. If the input HDMI source is HDMI 1.3 format, you can set the output format to HDMI 1.2 mode and Red LED will be on. If the input HDMI source is HDMI 1.2, the output format is always set to HDMI 1.2.
www.avenview.com | 8 |
|
|
