25

Chapter 4

Troubleshooting
This chapter provides many useful tips on how to solve common problems
while using the AVerKey300.
There is no picture on my TV.
1. Check all the connectors again as shown in this manual.
2. Check your TV remote control on/off switch and channel setting.
3. Verify the setting of the Composite Input or S-VHS Input of your TV
set.
4. If you are using a SCART connector, check the SCART input of your
TV set.
5. If you are using a notebook, you may have to switch to external VGA
mode. (Refer to your notebook’s manual.)
6. As specified by IBM, some systems may require that the monitor is
present and connected when the system is powered up.
7. If you are using the AVerKey300 on the Macintosh, you must have a
Macintosh monitor or Dummy Terminators connected.
When the signal runs through a VCR, there is no picture on the TV.
1. Check your TV/VCR input channel setting.
2. If your TV and VCR are connected to an AV Amplifier, please check
the input/output selection.