8Digital Desktop System Installer/User Guide
4.Remove the computer cover to access the interface cards.
5.If applicable, remove the current video and audio interface cards from the computer.
To configure the PCI Add In Card:
Several jumpers and two sets of connectors on the PCI Add In Card are used to configure your Digital Desktop System. An optional short bracket is also provided to accommodate a low profile PCI form factor.
1.Determine which PCI slot form factor is available for you to install the PCI Add In Card. The PCI Add In Card is shipped with a tall bracket mounted for use with standard PCI slots.
A short bracket is provided for low profile PCI slots. You may need to change the bracket before installing the PCI Add In Card.
2.Configure the PCI device jumpers on the PCI Add In Card. These jumpers allow you to selec- tively disable certain components of your Digital Desktop System. The factory default is set with all components enabled. Figure 2.3 identifies the enable/disable positions for each jumper. Table 2.1 identifies which PCI devices are controlled by each jumper.
Device Jumpers
Auxiliary Power Jumpers
Figure 2.2: PCI Add In Card Jumpers
J1 J2 J3 J4 J5 J6 J7 J8
Enable
Disable
Figure 2.3: PCI Add In Card Device Jumper Configuration
J9
1
2
3