Axis Communications manual Quick Installation Guide, Installing the Axis 200+

Quick Installation Guide

This guide covers the installation and basic setup procedures for your AXIS 200+. Should you require more detailed instructions, please refer to the AXIS 200+ User’s Manual available via the Axis WWW Home Page at http://www.axis.com/salessupport/manuals.html, or

http://www.se.axis.com/products/documentation/manuals.html

Control Snapshot Camera lens CS ring Lock ring button indicator

Front view

Power Ethernet

supply 10baseT RS232 I/O

Net indicator

Power indicator

Installing the AXIS 200+

Follow these instructions to install your AXIS 200+:

1.Record the serial number of your AXIS 200+. Please note that the serial number is identical to the Ethernet address of the unit.

2.Connect your AXIS 200+ to the network using an Ethernet 10baseT connector.

3.Connect the external power supply (Axis type PS-D), to the AXIS 200+ and check that the Power indicator is lit.

4.Acquire an unused Internet address for your AXIS 200+.

5.Assign the Internet address to your AXIS 200+ using the method appropriate for your network environment as detailed below:

Windows 95, Windows NT

Start a DOS window and type the following commands:

arp -s <Internet address> <Ethernet address> ping <Internet address>

Example:

arp -s 192.168.3.191 00-40-8c-10-00-86 ping 192.168.3.191

When using the Windows 95 implementation of ARP you must first, if you have an empty ARP table (seen with arp -a), ping an existing unit on your network before setting the Internet address.