AXIS | Page 13 |
AXIS NVR Manager
1.Connect to the NVR directly via a network cable or through the network and make sure that power has been applied.
2.Start AXIS NVR Manager.
3.AXIS NVR Manager will automatically discover all NVRs that are in the same network. Note that the NVR startup takes more than a minute and must be completed before it can be discovered.
ENGLISH
Set the password
The default user name is “Administrator” and password is “password”. It is strongly recommended that the Administrator password be changed at once to a strong password containing both upper and lower case letters and numbers.
1.Select the NVR in the AXIS NVR Manager window.
2.Go to Tools > Set Master Credentials.
3.Enter a strong password.
Network configuration
Network settings can be assigned either automatically or manually. Go to Tools > Network
Configuration
To access the NVR from behind a router UPnP™ must be enabled in AXIS NVR Manager. Check Enable UPnP™ under Network Configuration. When enabling UPnP™, the NVR needs to be in the subnet as your computer. Make sure that the router is UPnP™ capable and has UPnP™ enabled.
Caution:
For security reasons, enable UPnP™ in order to access the NVR via AXIS NVR Manager or AXIS Camera Station only when the NVR is behind a router that requires NAT traversal.
Power Configuration
To configure how the NVR powers on, go Tools > Power Configuration. The AXIS
Note:
If power configuration is done incorrectly you might not be able to start the NVR. To remedy this situation go to Resetting to the factory default settings, on page 11 and follow the instructions.
