8
Installation
Cut the installation box (i-box) so that it extends
1/16” outside the finished wall.
Remove the label.
Cut the eight support arms that connect the flush-
ing plug to the i-box. Remove the flushing plug.
Do not discard the screws.
Insert the cartridge in the rough. The locator tab
goes straight into the notch on the rough.
Use the flushing plug screws to connect the
cartridge retainer plate to the rough. Tighten the
screws evenly with a manual screwdriver. Do not
over tighten the screws.
Seal the wall around the i-box
with waterproof sealant.
Failure to seal the wall can lead
to possible water damage.
Turn the water off at the main, or at
the stops, before beginning.
Be sure that the blue sealing
gasket is removed as well.
Failure to remove the gasket
can result in possible damage
to the cartridge and possible
water damage.
notch
locator
tab
English