Preparation
The Waterwall requires 1/2” NPT male nipples, extend- ing 5/8” outside the surface of the finished wall for the hot and cold water supplies.
For proper operation of the thermostatic mixer, the hot supply should be on the left and the cold supply should be on the right.
Finish and seal the wall prior to installation of the Waterwall.
Flush the supply lines thoroughly before installation.
Installation
Drill the holes for the top and bottom mounting brack- ets, using a 6 mm bit. Install the anchors. Seal around the anchors with waterproof sealant.
Screw the mounting brackets to the wall with the screws provided.
Wrap the threads on the nipples with Teflon tape. Install the elbows so that the outlets face upwards.
Seal the wall around the nipples and anchors with waterproof sealant.
Failure to seal the wall can lead to possible water damage.
�� |
��� |
������ |
���� |
��� |
������ |
