Assembly
1.Flush pipe lines thoroughly.
2.Place the mixer including the sealing washer in position on the basin / bidet.
3.Slip the fixation piece including the washer over the threaded pin and tighten the nut.
4.Connect the supply pipes to the supply valves:
5.Connect the
Large differences in pressure between the hot and cold water supply should be balanced.
Technical Data |
| |
Operating pressure: | max. 147 psi | |
Recommended operating press.: | 14.7 - 72.5 psi | |
Test pressure: | 232 psi | |
Hot water temperature: | max. 176° F | |
Recommended hot water temp.: | 149° F | |
Hole size in deck: |
| |
Minimum: | 1 1/4" | |
Maximum: | 1 5/8" | |
Spare parts (see page 3) |
| |
1 | Handle for cold/hot water | 37299XXX |
2 | Screw cover cold/hot water | 96481XXX |
3 | Spout lav mixer | 96521XXX |
4 | Aerator lav mixer | 96336XXX |
5 | Stop unit | 94149000 |
6 | Lift rod | 94006XXX |
7 | Lift rod extension | 96617000 |
8 | Fixation set | 96016000 |
9 | Tube | 30622210 |
10 | Spout bidet mixer | 96522XXX |
11 | Aerator bidet mixer | 94005XXX |
XXX= Colors
000chrome
810satinox®
Install the pop-up drain
•Remove the plunger assembly.
•Unscrew the drain outlet flange from the tee.
•Unscrew the tailpiece from the tee. Wrap the threads with plumbers’ thread tape and replace.
•Install the white, flexible sealing gasket to the flange. Sit it in the sink outlet.
•From under the sink, install the black mack gasket, white friction ring , and retainer nut to the flange. Do not tighten the nut against the bottom of the sink at this time.
•Thread the tee and tailpiece to the flange. The pivot must face the faucet. If necessary, turn the drain assembly.
•Tighten the retainer nut.
•Sit the plunger assembly in the drain.
•Install the horizontal rod so that the end goes through the loop in the bottom of the height adjuster.
•Install and hand tighten the pivot ball nut.
•Attach the swivel connector to the end of the horizontal rod.
•Attach the swivel connector to the end of the vertical rod. Position as desired, and tighten with a small, flathead screwdriver.
plunger height adjuster
drain outlet flange
sealing gasket mack gasket friction ring
retainer nut
pivot ball nut
horizontal rod
swivel connector
tee
4