•Place a compression nut and ferrule over the spout tube.
•Install the mounting angle. Tighten the compression nut by hand, then finish tightening with a wrench.
•Screw the hot and cold connection hoses to the mounting angle.
•Place a compression nut and washer over the shank end of one of the connection hoses.
•Attach the hose to the outlet port on the valve with the compression fitting. Tighten with a wrench. Repeat with the other connection hose.
•Connect the valves to the stops with 1/2” supply lines and fittings (not included).
•After the drain is installed, turn on the water and check all connections for leaks.
